Fenix HM61R V2.0

Built tough and offering exceptional performance, Fenix HM61R V2 magnetically rechargeable head torch has been upgraded from the original model. Output has increased from 1200 to 1600 lumens, max beam range from 145 to 162m and a new snap-in head band system added for greater convenience when swapping between headlamp and worklight mode.HM61R V2.0 is designed primarily for job sites and tradesmen but is equally suitable for outdoor activities such as camping and fishing. With a fairly wide beam profile, this model is ideal for close work at lower brightness settings yet can reach out much further at high brightness.The lamp can be removed easily from the headband to be used as a right angle torch, and is highly adaptable with its pocket clip and magnetic tail cap enabling use as a right angle pocket light, tail standing light or magnetically attached work light.Fenix HM61R V2 performance:Eco: 5 lumens (12.5 days)9m beamLow: 50 lumens (35 hrs)28m beamMed: 150 lumens (12 hrs)47m beamHigh 600 lumens (3 hrs)97m beamTurbo: 1600 lumens (2 hrs inc temperature and battery level step downs)162m beamRed light:Low: 1 lumen (400 hrs)Med: 5 lumens (80 hrs)Flash: 5 lumens (160 hrs)Fenix tested run times at each output level are achieved by switching the light on and letting it run uninterrupted until the battery is drained as per the ANSI standard. Re setting the torch to a higher power level during operation will reduce these run times.Fenix HM61R V2 headlamp features:Digitally regulated power outputLockout mode helps prevent accidental operationLarge silicon rubber covered switch, easy to operate with gloved handsOperates from -35 to 45 degrees CIndustrial qualityA6061 T6 aluminium construction HA111 hard anodized finish2m drop testedIP68Waterproof 2m for 30 minutesReflective headband for safetyTilt adjustable headlamp mountingMagnetic snap-on charging cable (supplied)4 hour re charge from empty (charger dependent)Battery meter LED under the switch coverLight weight, comfortable to wear for long periodsCharging:HM61R V2 is supplied with a Fenix ARB-L18- 3400mAh 18650 battery, rechargeable on board using the included magnetic charging cable. Simply plug this into your phone charger or similar USB output device to charge your light. Place the cable near the receiver on the light head and it will snap into place and begin charging.For full product details please refer to the user manual in the images area.